Engine Systems
The full flow and by-pass filter elements should be
replaced, each time the engine oil is changed, as
follows:
1. Remove the drain plug and drain the oil (Fig. 18).
2. The filter shell, element and stud may be detached
as an assembly, after removing the center stud from
the base. Discard the gasket.
3. Clean the filter base.
4. Discard the used element, wipe out the filter shell
and install a new element on the center stud.
5. Place a new gasket in the filter base, position the
shell and element assembly on the gasket and tighten
the center stud carefully to prevent damaging the
gasket or center stud.
Fig. 18 - Typical Full-Flow Filter Mounting
6. Install the drain plug and, after the engine is
started, check for oil leaks.
Page 25