Fig. 24. inspect Packing Seals
Fig. 27. Reinstall Pistons
20. Reinstall pistons in cylinder bores by sliding piston thru
21. As piston slides into cylinder bore, snap lip on rubber
rubber boot as shown in Figure 27. Be careful not to
boot into groove on piston, being careful not to leave
Fig. 25. Reinstall Packings in Grooves
Fig. 28. Reinstall Retaining Caps
turn lip of boot under when installing piston. CAUTION:
lip on boot twisted. A properly fitted lip will insure a
Do not damage boot.
good seal.
Fig. 26. Reinstall Rubber Boots
Fig. 29. Install Carrier and lining
[8]