TM 5-3805-258-24-2
ENGINE
DISASSEMBLY AND ASSEMBLY
TIMING GEAR COVER
INSTALL TIMING GEAR COVER
1166-12
1. Install a new gasket on the timing gear plate.
Cut the gasket even with the bottom face of the
cylinder block. Put 5H2471 Gasket Cement on
the bottom of the gasket where the gasket
makes contact with the gasket for the oil pan
plate.
2. Put timing gear cover (1) in position on the
timing gear plate and install the bolts that hold
it in place.
NOTE: Tighten bolts (X) to a torque of 23 ± 4 N·m
(17 ± 3 lb.ft. ). For location of bolts (X) see picture
B53078X1 on Page 5-71.
3.
4.
5.
6.
7.
8.
9.
Put the O-ring seal and cover (2) in position on
the timing gear plate with the bolts that hold
them.
Be sure the O-ring seal is in position on trun-
nion (3). Put trunnion (3) in position on the
timing gear cover and install bolts (5). Tighten
the bolts to a torque of 135 ± 15 N·m (100 ±
11 lb. ft.).
Remove spacers (4) from between the oil pan
plate and the engine block.
Install alternator bracket (7) on the timing
gear cover.
Connect the ground wire to alternator bracket
(7).
Install adjusting bracket (9) to the timing gear
cover.
Connect fuel line (6) to the fuel priming pump
and clips (8) that hold the fuel line to the en-
gine.
end by:
a) install engine front support
b) install fan drive
c) install water pump
d) install air conditioning compressor
e) install alternator
f) install air compressor
5-72
