TM 5-3805-258-24-2ENGINEFUEL INJECTION4.5.6.7.8.9.Remove tooling (B) from the fuel injectionpump housing. The rack bearing must be in-stalled so it is 0.25 ± 0.25 mm (0.010 ± 0.010in.) below the surface of the housing.Install the fuel injection pump camshaft (1) inthe fuel injection pump housing.Put the fuel injection pump housing on end andput a block under the camshaft.Put washer (2) over the end of the camshaftand use tooling (A) and (C) to push washer (2)against its seat on the camshaft. The camshaftmust have 0.285 ± 0.235 mm (0.0112 ±0.0093 in.) end play when the washer is pushedagainst cam shoulder.Use tool (D) to install snap ring (3) in thegroove in the camshaft.DISASSEMBLY AND ASSEMBLYPUMP HOUSINGInstall four lifter assemblies (4) in the fuelinjection pump housing with the groove in thelifter in alignment with the pin in the housing.NOTE: The four lifters are all the same and can bemixed.5-102
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business