ENGINE
TM 5-3805-258-24-2
DISASSEMBLY AND ASSEMBLY
DISASSEMBLE GOVERNOR
GOVERNOR
1284-15
Tools Needed
A
B
C
1P510
Driver Group
1
1P1855 Snap Ring Pliers*
1
6V2163 Clamp Assembly Spring
Compressor*
1
*Part of 6V4095 Tool Group.
start by:
a) remove fuel injection pump housing and
governor
b) remove fuel transfer pump
c) on models 950BSCE and 950BNSCE
remove tachometer drive.
NOTE: If it is desired to remove only the governor so
the fuel injection pump housing can be disassembled,
do only Steps 1, 2, 15, 21, 25, 26, 27, 28, 31, 33, 34
and 37.
1.
2.
3.
Remove bolts (1) and remove fuel ratio control
(2). Remove the fuel shutoff solenoid.
Remove six bolts (3), two top bolts (4), housing
(5) and the gasket.
Remove governor spring (6), the two wave
washers, one flatwasher and seat from the
guide in the housing.
NOTE: For models 950BNSCE and 950BSCE,
governor lever has already been removed. Go
to step 5.
4. Make a mark of the position of lever (7) on
shaft (8). Loosen bolt (10). Use a chisel or
screwdriver to cause expansion of lever (7) so it
can be removed from shaft (8).
5-105
