ENGINE
TM 5-3805-258-24-2
DISASSEMBLY AND ASSEMBLY
FUEL INJECTION PUMP HOUSING
DISASSEMBLE FUEL INJECTION
PUMP HOUSING
1253-15
1.
2.
3.
start by:
a) remove governor from fuel injection pump
housing
Remove cover (1).
Install tooling (B). Engage the timing pin in the
center groove of the fuel rack. Move the fuel
rack in the direction of the arrow to find the
center groove.
Install tooling (D) and remove bushing (2).
4. Install tooling(E) and remove the fuel injection
pump.
5. Remove spacer (3).
6. Remove the remainder of the fuel injection
pumps and spacers with Steps 2-5 done again
for each fuel injection pump.
NOTE: Do not mix components from fuel injection
pump assemblies.
7. Remove cover (4).
5-98a/5-98b (blank)
