TM 5-3805-258-24-2
ENGINE
DISASSEMBLY AND ASSEMBLY
23.
24.
GOVERNOR
25.
26.
27.
28.
29.
30.
Remove valve (42), sleeve (47) and piston (49)
from the governor servo. Remove the O-ring
seal from sleeve (47).
Remove pin (48) and lever (50) from the gover-
nor servo.
Use tool (C) to hold spring (52) in compression
so ring (51) can be removed. Spring (52) is used
to put a preload on the thrust bearing for the
camshaft in the fuel injection pump housing.
Remove ring (51) then remove tool (C).
Remove bearing (53), sleeves (54) and spring
(52) from the governor shaft.
Remove ring (55) and dashpot assembly (56)
from the governor shaft.
Use tool (B) to remove snap ring (62) from seat
(59). Remove ring (61) and spool (60) from
seat (59).
Remove seat (59) from spring (58) and remove
spring (58) from seat (57).
5-109
