TM 5-3805-258-24-2ENGINEDISASSEMBLY AND ASSEMBLYGOVERNORASSEMBLE GOVERNOR1264-16Tools NeededABCD6V2054Shield Driver11P1855Snap Ring Pliers16V2163Clamp Assembly-Spring Compressor11P510Driver Group1NOTE:If the governor was removed only to permitrepair of the fuel injection pump housing, do onlySteps 1, 4, 5, 7, 9, 10, 11, 16, 22, 37, 39, and 40.NOTE: Put clean oil on all parts before assembly. Besure1.2.3.4.all oil passages are clear.Install one race (1), bearing (2) and the otherrace (1) on the camshaft in the fuel injectionpump housing.Put flyweights (3) in position on carrier (4) andinstall the dowels to hold the flyweights inplace. The flyweights must move freely on thedowels and have 0.010 to 0.23 mm (0.0004 to0.009 in.) end play.Install dowel (5) in governor shaft (6) and in-stall the governor shaft in the carrier as shown.Put the carrier in position on the camshaft andinstall the bolts that hold the carrier in place.5-112
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
