TM 5-3805-258-24-2
POWER TRAIN
DISASSEMBLY AND ASSEMBLY
105.
106.
107.
108.
109.
110.
TRANSMISSION
Install ring (129) on the carrier.
Make a compression of ring (129) and install
carrier (128) in the gear until the ring fits into
the groove of the gear.
Use tool (A) to install ring (130) on the shaft.
Check to make sure the pistons are free in their
clutch housings with tool (K) as follows:
a) Put air free of water under a pressure of 690
to 1030 kPa (100 to 150 psi) into each of
the six oil passages.
b) If the pistons do not move, put a small
amount of clean SAE 30 oil in each pas-
sage. Check for movement again. If the
pistons still do not move, the transmission
must be disassembled and the pistons and
seal rings checked.
Install seals (131) and (132) on the transmis-
sion case.
Fasten two of tooling (B) and a hoist to the No.
1 clutch housing as shown. Lower the transmis-
sion into the transmission case. Install the two
bolts that hold them together. The weight of the
transmission is 293 kg (650 lb.).
5-297
