TM 5-3805-258-24-2
POWER TRAIN
TRANSFER
14.
15.
16.
17.
18.
19.
20.
Install O-ring seal (15) on the cage.
Put 7M7260 Liquid Gasket Material in the
seal bore in cage (14) and let it dry. Do not put
the liquid gasket material on the lip of the seal
case. Use tooling (A) and install the seal in cage
(14) with the lip of the seal toward the inside as
shown. Put clean power train oil on the lip of
the seal.
Put clean power train oil on the O-ring seal and
install cage (14) on the case.
Install yoke (16) on the end of the output shaft.
Install O-ring seal (18), retainer (19) and bolt
(17) on the end of yoke (16). Put clean power
train oil on the O-ring seal. Tighten the bolt to a
torque of 110 ± 10 N•m (80 ± 7 lb. ft.).
Use a hoist and put the transfer gear case in a
horizontal position.
Install spacer (20) on the end of the output
DISASSEMBLY AND ASSEMBLY
GEARS
shaft.
5-308
