Lower the temperature of bearing cup

The bearing axis must be in a vertical position

Put clean power train oil on O-ring seal

TM-5-3805-258-24-2 Loader Scoop Type DED 4x4 Articulated Frame Steer 2 1/2 Cubic Yard Bucket (CCE) Airborne/Airmobile Sectionalized and Nonsectionalized Manual
Page Navigation
356

TM 5-3805-258-24-2 POWER TRAIN DISASSEMBLY AND ASSEMBLY TRANSFER GEARS 27. 28. 29. 30. 31. Install yoke (26) on the output shaft. Put clean power train oil in the bore and on the O-ring seal. Install O-ring seal (29), spacer (28) and bolt (27) on the end of the output shaft. Tighten the bolt to a torque of 110 ± 10 N•m (80 ± 7 lb. ft.). Lower the temperature of bearing cup (30) and install it in the case as shown. Heat bearing cones (31) to a maximum tem- perature of 135° C (275° F) and install them on each side of gear (32). Install gear (32) in the case as shown. 5-310

Privacy Statement
Press Release
Contact