PISTON AND ROD REMOVAL

DISASSEMBLE AND ASSEMBLE - TM-5-3805-258-24-2_43

TM-5-3805-258-24-2 Loader Scoop Type DED 4x4 Articulated Frame Steer 2 1/2 Cubic Yard Bucket (CCE) Airborne/Airmobile Sectionalized and Nonsectionalized Manual
Page Navigation
33

TM 5-3805-258-24-2 ENGINE DISASSEMBLY AND ASSEMBLY AIR COMPRESSOR PISTON AND ROD Models 950BNS and 950BS PISTON AND ROD REMOVAL 11–1065 start by: a) remove head assembly 1. Remove cylinder (1) and gasket (2). 2. Remove bolts (3) and end cover (4). 3. Remove four bolts and cover (6). 4. Put marks on rod cap (9) and rod (10) so rod and rod cap can be installed on crank- shaft (11 ) in the same location as they were removed. 5. Bend lock (7) and remove bolts (8) and rod cap (9). Remove rod (10) and piston (12) from crankcase (5). 6. Mark piston (12) so it can be installed on rod (10) in the same location as it was removed. 7. Remove pin lock (13) and push pin (4) out of piston (12) and rod (10). 8. Clean all parts. 9. Remove piston rings and clean the ring grooves in piston (12) with a piece of hard wood . 5-16

Privacy Statement
Press Release
Contact