TM 5-3805-268-24-2VEHICLE SYSTEMSDISASSEMBLY AND ASSEMBLYSTEERING CONTROL VALVEModels 950BNSCE and 950BSCEREMOVE AND INSTALLSTEERING CONTROL VALVE4102-010Start By:a. connection of steering frame link lockTo prevent personal injury release the pressurefrom the hydraulic system before any lines are re-moved or disconnected.REMOVE STEERING CONTROLVALVE1. Drain the oil half way down in the hydraulic tank.2. Remove bolts (1) that hold hose (2) to the steeringcontrol valve manifold. Remove hose (2) and bolts (3)that hold the steering control valve manifold to thesteering control valve.3. Remove front oil line (4) and rear oil line (not shown).Remove bolts (7) that hold steering control valvemanifold (5) to steering control valve (10).4. Remove oil line (8) from elbow (11). Remove bolts(9), and move elbow (11) away from steering controlvalve (10).5. Remove bolts (6), and remove steering control valve(10).INSTALL STEERING CONTROLVALVE1. Check the condition of all O-ring seals beforethe steering control valve is installed. If any areworn or damaged, make a replacement with newparts.2. Position steering control valve, and installbolts (6) that hold it in place.3. Position elbow (11), and install bolts (9) thathold it. install oil line (8) on elbow (11).4. Install bolts (7) that hold steering control valvemanifold (5) to steering control valve (10). Installfront oil line (4) and rear oil line (not shown).5. Install bolts (3) that hold steering control valve(10). Position hose (2), and install bolts (1).6. Fill the hydraulic tank. See the MaintenanceGuide.End By:a. separation of steering frame lock line5-388
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
