TM 5-3805-258-24-2
VEHICLE SYSTEMS
DISASSEMBLY AND ASSEMBLY
TRANSMISSION NEUTRALIZER GROUP
8. Remove two screws (14) from each switch. Re-
move wiring harness (15) and switches from
the housing as a unit.
9. Disconnect wires (17) and (18) from the
switches. Put identification on the wires so they
will not be mixed at assembly.
10. Remove switches (16).
ASSEMBLE TRANSMISSION
NEUTRALIZER GROUP
3181-16
1.
Put switches (1) and (3) in position on the
wiring harness. Connect wires- (2) and (4) to
the switches. Make sure the wires are installed
in their original position.
NOTE: Remove the screw from the switch terminal
that is not used.
2. Install switches and wiring harness (5) in hous-
ing (6). Tighten the screws and nuts to a torque
of 0.5 ± 0.1 N•m (5 ± 1 lb.in.).
5-428
