ENGINE
AIR GOVERNOR
Models 950BNS and 950BS
DISASSEMBLE AIR GOVERNOR
15–1
065
1. Remove air governor from air compressor. Re-
move air line (1) from body (11).
2.
3.
4.
5 .
6.
7.
Put a mark (A) on cover (4) and body (11)
so the cover can be installed on the body in
the correct location.
Measure the distance from cover (4) to the
top of screw (5) and make a record of the
measurement. Loosen the locknut and re-
move screw (5).
Remove four screws (2), identification tag
(3), cover (4), spring (6) and spring seat (7).
Remove nut (8), plunger (10) and dia-
phragm (9) as a unit.
A rod with a diameter of .12 in. (3.05 mm)
put in the hole in plunger (10) is used to
hold the plunger when nut (8) is removed.
Remove screw (17) and exhaust diaphragm
(16).
8. Remove exhaust nut (14), spring (15), ex-
haust valve (12) and spring retainer (13).
TM 5-3805-258-24-2
DISASSEMBLY AND ASSEMBLY
9. Clean all of the parts and the passages in
body (11) and plunger (10).
5-19
