TM 5-3805-258-24-2OPERATOR’S STATIONDISASSEMBLY AND ASSEMBLY29.30.31.32.Put latch assembly (43) and spring (42) in posi-tion on the suspension group. Install lever (41).Install the pin in the latch assembly and lever.Put bracket assemblies (44) in position on thelink assembly. Use a piece of pipe with a 15.9mm (.625 in. ) inside diameter approximately12.7 cm (5 in. ) long to install the retainers thathold the bracket assemblies.Put bar (45) in position between the bracketassemblies. Install spacers (46), cables (48), andbolts (47).Connect the cables to the plate.NOTE: After assembly the cables must make a curvetoward the front of the seat as shown.33. Put latch assembly (50) on the shaft. Install shaft(49) in the cushion assembly. Slide latch assem-bly into position on the shaft until the holes in theshaft and latch assembly are in alignment. Installthe pin in the latch assembly and shaft.34. Install the springs on the latch assembly andcushion assembly.5-488
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business