TM 5-3805-262-20REMOVAL (SHEET 2 OF 5)( 2 ) I f n e c e s s a r y , a t r o d e n d o f c y l i n d e r a s s e m b l y , r e m o v e l u b r i c a t i o n f i t t i ng( 1 ) .(3) Loosen and remove lock nut (2) and capscrew (3).(4) Using hammer and 1-7/8 inches diameter rod, drive pivot pin (4) out ofbellcrank and cylinder assembly rod end eye as shown.(5) Start engine and operate at idle speed. Place BUCKET control lever inCROWD position to retract cylinder assembly rod. Turn off engine and moveBUCKET control lever in both directions to relieve hydraulic pressure.11-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business