TM 5-3805-262-20
11-1. BUCKET TILT CYLINDER ASSEMBLIES MAINTENANCE (CONT)
b. Replacement (cont).
REMOVAL (SHEET 5 OF 5)
(14) Remove elbow (16) and 0-ring (17). Discard 0-ring.
NOTE
R e p e a t s t e p s ( 1 1 ) t h r o u g h ( 1 4 ) a b o v e t o r e m o v e p a r t s f r o m r e m a i n i ng
cylinder assembly.
NOTE
Perform following steps only if these parts are not already installed
replacement cylinder assembly.
(1)
(2)
(3)
(4)
(5)
Install new 0-ring (17) on elbow (16). Install and tighten elbow
Install new 0-ring (15) on elbow (14). Install and tighten elbow
Connect tube (12) to elbow (16). Hand tighten tube (12) fitting.
on
( 1 6 ).
( 1 4 ).
Position saddle (13) between cylinder assembly body and tube (12). In-
stall new clamp (11) securely ensuring that tube is properly seated on
s a d d l e.
Using a chain hoist equipped with nylon straps, install cylinder assembly
on pivot shaft.
11-8
