TM 5-3805-262-2011-3. LINES AND FITTINGS MAINTENANCE (CONT)b. H y d r a u l i c P u m p t o R e s e r v o i r .This tasks covers removal, cleaning, inspection,and installation of hoses, lines, and fittings located between hydraulic pump andh y d r a u l i c r e s e r v o i r.TOOLS: No. 1 Common Organizational Maintenance Tool KitFixed open end wrench setSocket wrench set, 3/8 inch driveMATERIALS/PARTS: Clean cloths (Appendix C, item 1)Cleaning solvent P-D-680 (Appendix C, item 2)Detergent (Appendix C, item 3)Hydraulic oil (Appendix C, item 13)0-rings, two (FSCM0-ring (FSCM 10988PRELIMINARY PROCEDURE: Engine10988 PN A14506)PN 218-5012)NOTEright side panels removed (page 9-14) andh y d r a u l i c r e s e r v o i r d r a i n e d ( p a g e 1 1 - 7 9 ) .REMOVAL (SHEET 1 OF 2)NOTEPlug or cap tubes and hoses disconnected or removed in following stepsto prevent foreign matter from entering hydraulic system.In following steps, identify and tag all hoses and lines before discon-necting and removing to aid in installation.( 1 ) A t l e f t s i d e o f l o a d e r,loosen two clamps (1 and 3).(2) Disconnect two hoses (2 and 4) by firmly pulling from manifold ports.11-25
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business