TM 5-3805-262-20
11-3. LINES AND FITTINGS MAINTENANCE (CONT)
a. Hydraulic Pump to Control Valve A s s e m b ly
( c o n t ).
REMOVAL (SHEET 2 OF 2)
NOTE
cut , remove, and discard tie straps as necessary in following steps.
(6) Remove nut (14), lock washer (15), clamp (16), spacer (17), and capscrew
( 1 8 ).
( 7 ) I f n e c e s s a r y , remove nut (19), lock washer (20), clamp (21), capscrew
(22), and clamp (23).
(8) Loosen tube (24) fitting and disconnect and remove hose (13).
(9) If necessary, remove dust cap (25), coupling (26), and connector (27).
(10) Remove two nuts (28) and lock washers (29); remove U-bolt (30).
(11) Remove four capscrews (31),
lock washers (32), and two tube flanges (33);
remove tube (24) and 0-ring (34). Discard 0-ring (34).
11-20
