TM 5-3805-262-20
REMOVAL (SHEET 2 OF 2)
(3)
(4)
(5)
(6)
(7)
( 8)
( 9)
At rear of hydraulic reservoir, loosen clamp (5) and disconnect hose (9)
from reservoir by firmly pulling from reservoir port. Remove clamp (5)
from hose.
At other end of hose (9), loosen and remove four capscrews (6) and lock
washers (7). Remove two flanges (8).
Remove hose (9) and 0-ring (10); discard 0-ring (10).
At hydraulic pump, loosen two clamps (20).
Loosen and remove four capscrews (11) and lock washers (12). Remove two
tube flanges (13).
At front of transmission, loosen and remove two nuts (14), lock washers
(15), and washers (16). Remove U-bolt (17).
Grasp manifold (18) and gently but firmly pull from hydraulic pump and
hose (21). Remove manifoid from loader. Remove 0-ring (19); discard
0 - r i n g.
(10) Remove two clamps (20).
(11) Remove hose (21) by firmly pulling from connector (22).
(12) If necessary, remove connector (22) and 0-ring (23). Discard 0-ring (23).
(13) If necessary, loosen and remove capscrew (24) and lock washer (25).
Remove bracket (26).
CLEANING (SHEET 1 OF 2)
(1) Clean hoses (9 and 21) using detergent; dry using clean cloths.
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a
a r e a . A v o i d c o n t a c t w i t h s k i n , e y e s a n d c l o t h e s a n d
v a p o r s . D o n o t u s e n e a r o p e n f l a m e o r e x c e s s i v e h e at
w h e n u s i n g i t . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s
b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e sh
a t t e n t i o n i m m e d i a t e l y . I f c o n t a c t w i t h s k i n o r c l o t h es
w i t h l a r g e a m o u n t s o f w a t e r . I f c o n t a c t w i t h e y e s is
with water and get medical aid immediately.
w e l l v e n t i l a t e d
d o n t b r e a t h e
and dont smoke
i n j u r y . I f y o u
air and medical
i s m a d e , f l u s h
made, wash eyes
(2) Clean remaining parts using clean cloths moistened with cleaning solvent
P-D-680; dry using clean cloths.
11-27