TM 5-3805-262-20
3-4. ENGINE TROUBLESHOOTING (CONT)
MALFUNCTION
TEST OR INSPECT ION
CORRECTIVE ACTION
8. ENGINE CRANKS BUT DOES NOT START WHEN COLD START AID IS ACTIVATED (Cont).
Step 4.
Disconnect connector from solenoid by
grasping with your fingers and firmly
p u l l i n g u p o n i t.
Connect multimeter between connector
contact to which black-orange wire
connected and chassis frame,
T e l l a s s i s t a n t t o p l a c e i g n i t i o n k ey
switch in start position and press
COLD START switch at same time.
Multimeter should indicate 24 volts.
a. If multimeter indicates 24 volts,
replace solenoid (page 4-50).
b. If multimeter does not indicate
24 volts, remove right instrument
panel (page 5-48) and replace
COLD START
9. LOW ENGINE OIL PRESSURE.
Step 1.
Remove engine
At engine oil
grasping with
switch (page 5-53).
left side panels (page 9-14).
pressure switch, disconnect wiring harness lead by
fingers and firmly pulling from switch contact.
3-36
