TM 5-3805-262-20SHEET 2 OF 2Do not use filter wrench to install filter in following step. To do sowill make it difficult to remove later or may cause an oil leak due tofilter element being dented or distorted by filter wrench.(4)( 5)(6)( 7)(8)( 9)(10)(11)Apply thin coat of clean hydraulic oil on new gasket (3) and threads ofn e w f i l t e r ( 2 ).I n s t a l l g a s k e t ( 3 ) o n f i l t e r h e a d .Turn filter (2) on filter head until gasket makes contact with filterhead. Hand tighten an additional 1/2 to 3/4 turn.Replace steering hydraulic filter (page 8-42).Tighten hydraulic reservoir fill cap (1) and close and lock front accessdoor.Start engine and operate at 1000 rpm. Operate CLAM, BUCKET, and LIFT ARMcontrol levers several times to remove air from hydraulic system.Turn steering wheel in both directions several times to remove air fromsteering hydraulic system.Lower bucket to ground and turn off engine. Check for hydraulic oil leak-a g e a t f i l t e r s . C h e c k o i l l e v e l ; a dd oil as necessary (page 11-78).11-83
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
