TM 5-3805-262-20REMOVAL (SHEET 2 OF 2)H y d r a u l i c s y s t e m p r e s s u r e i s o v e r 2 0 0 0 p s i a n d h y d r a u l i c r e s e r v o i r ispressurized with compressed air. Before loosening or disconnecting anyh y d r a u l i c h o s e s , l i n e s , o r f i t t i n g s ,l o o s e n h y d r a u l i c r e s e r v o i r f i l lc a p , a n d o p e r a t e a l l h y d r a u l i c c o n t r o l l e v e r s t o r e l i e v e h y d r a u l i csystem pressure. Failure to do so could cause serious injury or death.If you are injured obtain medical assistance immediately.(3)(4)(5)(6)( 7)(8)(9)(10)(11)(12)(13)(14)Loosen two clamps (2).Loosen tube fitting (3) and disconnect tube (4) from connector (12) andhose (5) by firmly pulling from hose.Remove hose, (5) by firmly pulling from hydraulic reservoir port.If filter head or tube (19) are to be removed , remove nut (6) and discon-nect wiring harness terminal (7).Remove nut (8), switch (9), and0-rings (10 and 11); discard0 - r i n g s .If necessary, remove connector(12) and 0-ring (13). Discard0 - r i n g.Loosen two tube fittings (14 and 15).Remove two capscrews (16) and lockwashers (17).Raise bracket (18) with filter head (23)attached just enough to disconnect elbow(24) from tube (19). Remove bracket (18)with filter head (23) attached and tube(19) from loader.If necessary, remove three capscrews (20),lock washers (21), and washers (22). Sep-arate bracket (18) and filter head (23).If necessary, remove elbow (24) and 0-ring(25) from filter head (23). Discard 0-ring.If necessary, remove connector (26) and0-ring (27) from control valve assembly.Discard 0-ring .11-85
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
