TM 5-3805-262-20
INSTALLATION (SHEET 2 OF 2)
NOTE
I f n e w t u r n s i g n a l s w i t c h ( 1 2 ) i s b e i n g i n s t a l l e d , d i s c a r d m o u n t i ng
strap supplied with switch.
( 5)
Route turn signal switch (12) wires through hole in bracket (11) and po-
sition switch on bracket.
(6)
(7)
( 8)
( 9)
(10)
(11)
(12)
(13)
(14)
(15)
Install and tighten two lock washers (10) and screws (9).
Route turn signal switch (12) wires through hole in cover and position
bracket (11) with switch on cover.
Install and tighten two lock washers (8) and capscrews (7).
Route turn signal switch (12) violet wire spade terminal (6) to flasher.
Connect spade terminal to flasher terminal No. 2 by grasping spade term-
inal with finger and firmly pushing onto flasher terminal.
Route turn signal switch light blue and white-blue wires down steering
column and secure to steering column using two tie straps (1).
Connect white-blue wires terminal (5 and 4) by grasping terminals with
fingers and firmly pushing them together.
Connect light blue wires terminal (3 and 2) by grasping terminals with
fingers and firmly pushing them together.
Connect battery ground cable (page 5-151).
Place key switch in ON position and place turn signal lever in up posi-
tion then in down position. Check that lamp within switch and directional
signal lamps mounted at top of cab flash on and off.
Return turn signal switch lever to middle position and turn off key
switch .
12-15
