TM 5-3805-262-20
12-1. SIGNALING DEVICES MAINTENANCE (CONT)
e. Turn Signal Lamp Assemblies.
This task covers removal and installation of
turn signal lamp assemblies installed on cab at top.
TOOLS: No. 1 Common Organizational Maintenance Tool Kit
Screwdriver
Fixed open end wrench set
E l e c t r i c a l r e p a i r t o o l k it
MATERIALS/PARTS: Insulation tape (Appendix C, item 5)
REMOVAL
(1)
( 2)
(3)
(4)
P u ll
j u st
ness
Adhesive (Appendix C, item 8)
back cab foam at inside, top of cab
enough to gain access to wiring har-
w i r e t e r m i n a l ( 1 ).
Disconnect terminals (1 and 2) by grasping
terminals with your fingers and firmly
pulling them apart .
Loosen and remove nut (3) and lock washer
( 4 ) .
Pull lamp assembly (8) from top of cab and
remove rubber washer (5), washer (6) and
lock washer (7).
NOTE
Repeat steps (1) through (4) above
to remove remaining lamp assembly.
Refer to page 12-16 to disassemble
lamp assembly (8).
12-17
