TM 5-3805-262-203-32. CHARGING SYSTEM TROUBLESHOOTING (CONT)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION1. ALTERNATOR NOT CHARGING BATTERIES (Cont).S t e p 2 . ( C o n t ) .Turn off loader driving lamps, flood lights, accessories, and engine.Disconnect test probe cable W2 test clips from alternator BAT termi-nala .b .and loader or alternator frame.If VTM displays 26.5 to 31 volts, check for loose wiring connec-tion between alternator BAT terminal, starter relay, and startersolenoid. If connections are tight, check brown wire between al-ternator BAT terminal and starter relay and cable betweenstarter relay and starter solenoid for open circuit. Repair orreplace wire or cable as necessary (page 5-174).If voltage is less than 26.5 volts, go to step 3 below.Step 3.Connect transducer cable W4 connector P1 to VTM J2.Connect transducer cable W4 connector P2 to current probe (TK item11).Clamp current probe around battery positive cable with current probearrow pointing away from battery. Be sure current probe is closed.Shut off fuel by pulling fuel SHUT OFF control out.Dial 10 into VTM TEST SELECT and press and release TEST button.Crank engine for 10 seconds then turn ignition key switch to off po-s i t i o n .Remove current probe from around battery positive cable.S t a r t e n g i n e.3-258
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
