TM 5-3805-262-204-2. FUEL SYSTEM MAINTENANCE (CONT)h. A c c e l e r a t o r .T h i s t a s k c o v e r s r e m o v a l , c l e a n i n g , i n s p e c t i o n , i n s t a l l a t i o n ,and adjustment of accelerator linkage including fuel shutoff cable.TOOLS: No. 1 Common Organizational Maintenance Tool KitSocket wrench set, 3/8 inch driveFixed open end wrench setR e t a i n i n g r i n g p l i e r sStroboscope tachometer or tachometerMATERIALS/PARTS: Clean cloths (Appendix C, item 1)Cleaning solvent P-D-680 (Appendix C, item 2)Detergent (Appendix C, item 3)Air-drying adhesive (Appendix C, item 8)D i e s e l f u elTie straps (FSCM 06383 PN SST2S0)PERSONNEL REQUIRED: Two Construction Equipment Mechanics M0S 62BNOTEPRELIMINARY PROCEDURE: Engine right side panels removed (page 9-14) andt a c h o m e t e r c a b l e d i s c o n n e c t e d f r o m t a c h o m e t e r d r i v e a s s e m b l y ( p a ge5-65) .REMOVAL (SHEET 1 OF 2)(1)(2)(3)(4)(5)(6)(7)At fuel injection pump, remove nut(1) and lock washer (2) and disconnectball joint (3) from fuel injection pump accelerator lever.At bracket (24), remove two screws (6), nuts (7), lock washers (8), andwashers (9). Remove clamp (10) and spacer (11) from accelerator cable( 5 ) .At fuel injection pump, disconnect fuel shutoff cable (16) from fuelinjection pump stop lever.At bracket (24), remove two screws (12) and nuts (13), and four lockwashers (14). Remove clamp (15) from fuel shutoff cable (16).Remove capscrew (17) and lock washer (18) then remove clamp (19) fromf u e l s h u t o f f c a b l e ( 1 6 ) .If necessary, remove capscrew (20),lock washer (21), capscrew (22), andlock washer (23). Remove bracket (24).If cables (5 and 16) are to be replaced, cut, remove, and discard tiestraps (25) as necessary.4-54
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
