TM 5-3805-262-20INSPECTION , TESTING, AND REPAIR (SHEET 1 OF 5)(1)Inspect wiring harness terminal (10, 11, 14, 20, 21, and 22) wires forcracked or broken insulation or broken wire strands at connection to ter -minals. Repair cracked or broken insulation by applying insulation tapeto area. If broken wire strands are seen, cut wire as close to terminalas possible. Strip 1/4 inch insulation from end of wire taking care notto cut through wire then crimp new terminal securely onto wire.( 2 ) I n s p e c t i g n i t i o n s w i t c h c o n n e c t o r ( 1 8 ) w i r e s f o r c r a c k e d o r b r o k e n i n s u-lation or broken wire strands at connection to terminals. Repair crackedor broken insulation by applying insulation tape to area. If broken wirestrands are seen, replace terminal as follows:(a) Remove terminal from connector by prying tab using small screwdriver andpulling terminal from connector as shown.(b) Cut wire as close to terminal asp o s s i b l e.(c) Strip 1/4 inch insulation from endof wire taking care not to cutthrough wire.(d) Crimp new terminal securely ontow i r e.(e) Aline terminal with connector andpush into connector until terminalt a b c l i c k s.5-55
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business