TM 5-3805-262-20REMOVAL (SHEET 2 OF 2)(7) In operator’s compartment, below relay socket assembly, tag and discon-nect three flow switch wiring harness (25) terminals by grasping withfingers and pulling firmly apart.(8) At right side of loader, at flow switch, tag and disconnect three flowswitch wiring harness (25) terminals by grasping with fingers and pullingf i r m l y a p a r t.NOTEDo the following steps only if necessary to replace flow switch wiringh a r n e s s.( 9 ) A t t o p o f t r a n s m i s s i o n,loosen and remove nuts (17), lock washers (18),clap (19), clamps (20), and spacers (21), capscrews (22), C l a mP ( 2 3 ) ,and clamps (24).(10) Spread and remove clamps (19 and 23) only if necessary for replacement.(11) Remove flow switch wiring harness (25) from loader.CLEANING(1) Clean cable and wire insulation using clean cloth moistened with deter-gent. Dry using clean cloth.(2) Clean terminals using clean cloth moistened with isopropyl alcohol.Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t eda r e a . A v o i d c o n t a c t w i t h s k i n , e y e s a n d c l o t h e s a n d d o n ’ t b r e a t h ev a p o r s .D o n o t u s e n e a r o p e n f l a m e orexcessive heat and don’t smokewhen using it. Failure to do so could cause serious injury. If you be-c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c ala t t e n t i o n i m m e d i a t e l y .If contact with skin or clothes is made, flushwith large amounts of water.I f c o n t a c t w i t h e y e s i s m a d e , w a s h e y eswith water and get medical aid immediately.(3) Clean all other metallic parts using clean cloth moistened with cleaningsolvent P-D-680. Dry using clean cloths.5-87
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
