TM 5-3805-262-205-6. AUXlLIARY STEERING ELECTRICAL SYSTEM MAlNTENANCE (CONT)b. Auxiliary Steering Cables and Harness (cont).INSPECTION(1)(2)( 3 )AND REPAIRInspect cables and wires for cracked or broken insulation or broken wirestrands at connection to terminal. Repair cracked or broken insulation byapplying insulation tape to area. If broken wire strands are seen, re-place cable or wire.Inspect flow switch wires for cracked or broken insulation or broken wirestrands at connection to terminal. Repair cracked or broken insulation byapplying insulation tape to area . If broken wire strands are seen, cutwire as close to terminal as possible. Strip 1/4 inch insulation from endof wire taking care not to cut through wire then crimp new terminal se-curely onto wire.Inspect remaining parts for cracks, breaks, distortion, or damagedt h r e a d s; replace as necessary .INSTALLATION (SHEET 1 OF 2)(1)( 2)(3)(4)Position flow switch wiring harness (25) in loader and route as notedduring removal.In operator-s compartment, below relay socket assembly, connect threeflow switch wiring harness (25) terminals as tagged by grasping withfingers, alining, and pushing firmly together.At right side of loader, at flow switch, connect flow switch wiringharness (25) terminals to flow switch terminals as tagged by graspingwith fingers, alining, and pushing them firmly together.At top of transmission, install clamps (20 and 24), spacers (21), andclamps (19 and 23) using capscrews (22), lock washers (18), and nuts( 1 7 ).5-88
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business