TM 5-3805-262-207-2. SERVICE BRAKE SYSTEM MAINTENANCE (CONT) d. H o s e s . L i n e s,a n d F i t t i n g s ( c o n t ).(2) FrontREMOVAL (SHEET( e ) A tBrakes Hoses, Lines, a n d F i t t i n g s ( c o n t ).2 OF 2)other end of hose (4), loosen clamp (3) and disconnect hose fromadapter (5) at top of brake actuator. Do this by firmly grasping hoseand pulling from adapter. Remove clamp and hose from loader.(f) At rear of brake actuator, loosen and disconnect tube fitting (6) froma d a p t e r ( 9 ).(g) Loosen and remove fitting (7), gasket (8), adapter (9), and gasket (10) .Discard gaskets (8 and 10).(h) Loosen and disconnect tube fitting (11) from tee (30). Remove tube (12)from loader.(i) At either left or right axle end, at axle mounting hardware, loosen andremove nut (13), lock washer (14), capscrew (15), and spacer (16).(j) Spread clamp (17) and remove from tube (25). Spread clamp (18) and re-move from axle mounting capscrew.( k ) A t e i t h e r l e f t o r r i g h t b r a k e c a l i p e r,loosen and disconnect tube fit-ting (19) from adapter (22).(l) Loosen and remove fitting (20), gasket (21), adapter (22), and 0-ring(23). Discard gasket and 0-ring.(m) Loosen and disconnect tube fitting (24) and remove tube (25) from load-e r .NOTERepeat steps (i) through (m) above to disconnect and remove remainingtube (26) from loader.(n) At top center of axle housing, remove nut (27), lock washer (28), andcapscrew (29). Remove tee (30).(o) If necessary, remove differential assembly mounting nut (31) and washer(32) and remove bracket (33).7-36
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business