TM 5-3805-262-20
7-2. SERVICE BRAKE SYSTEM MAINTENANCE (CONT)
d. Hoses, Lines and Fittings.
(1) Inspection .
This task covers inspection of hydraulic brake system hoses,
l i n e s , a n d f i t t i n g s .
TOOLS: No. 1 Common Organizational Maintenance Tool Kit
Fixed open end wrench set
F l a t t i p s c r e w d r i v er
Extension light
NOTE
PRELIMINARY PROCEDURE: Engine left side panels removed (for access to
r e a r b r a k e s h y d r a u l i c r e s e r v o i r ) ( p a g e 9 - 1 4 ) ; f r o n t a c c e s s d o o r o p en
(for access to front brakes hydraulic reservoir).
INSPECTION (SHEET 1 OF 2)
(a) Inspect hoses between hydraulic reservoirs
and brake actuators for deterioration,
cracks,
chafing, or other damage. If any
of these conditions are observed, replace
the part (page 7-34 or 7-42).
(b) Check for brake fluid leakage at hy-
draulic reservoirs and brake actua-
t o r s w h e r e f i t t i n g s a r e i n s t a l l e d in
ports and at hose connections. If
leakage is observed, tighten
fittings and clamps. If leakage
continues,
replace the part (page
7-34 or 7-42).
7-32
