TM 5-3805-262-20
7-2. SERVICE BRAKE SYSTEM MAINTENANCE (CONT)
d. H o s e s , L i n e s, a n d F i t t i n g s ( c o n t ) .
(2) Front Brakes Hoses, Lines, and Fittings.
This task covers removal, clean-
ing, inspection, and installation of front hydraulic brake system hoses, lines, and
f i t t i n g s .
TOOLS: No. 1 Common Organizational Maintenance Tool Kit
Socket wrench set, 3/8 inch drive
Fixed open end wrench set
Container, 1 quart capacity
Chocks, two
MATERIALS/PARTS:
Clean cloths (Appendix C, item 1)
Cleaning solvent P-D-680- (Appendix C, item 2)
Detergent (Appendix C, item 3)
Brake fluid (Appendix C, item 11)
0-rings, two (FSCM 10988 PN A12988)
Gaskets, three (FSCM 10988 PN 33261)
Gasket (FSCM 10988 PN 33260)
NOTE
PRELIMINARY PROCEDURE: Wheels blocked and front access door unlocked and
opened.
REMOVAL (SHEET 1 OF 2)
NOTE
Plug and cap all tubes, hoses, o r f i t t i n g s d i s c o n n e c t e d o r r e m o v e d i n
following procedures to prevent dirt or other contaminants from entering
brake system.
Tag and identify all hoses and tubing before disconnecting and removing.
( a ) P o s i t i o n c o n t a i n e r u n d e r f r o n t b r a k e h y d r a u l i c r e s e r v o i r .
(b) Loosen clamp (1) and disconnect hose (4) from adapter (2). Do this by
firmly grasping hose and pulling from adapter. Drain brake fluid from
r e s e r v o i r .
(c) Remove clamp (1) from hose (4).
(d) If necessary, remove adapter (2) from brake hydraulic reservoir.
7-34
