TM 5-3805-262-20
INSTALLATION (SHEET
( a a )
(ab)
( a c )
(ad)
( a e)
( a f )
(ag)
(ah)
( a i )
( a j )
(ak)
( a l )
I n s t a l l
c o n t r ol
tight en
Connect
5 OF 5)
new 0-ring (8) on hose (6) fitting. Route hose (6) between flow
valve and-tube (7). Connect
h o s e f i t t i n g s e c u r e l y.
opposite end of hose (6) to
hose fitting to flow control valve;
t u b e ( 7 ) . T i g h t e n t u b e ( 7 ) f i t t i n gs
s e c u r e l y .
Connect and tighten hose (5) fitting to tee (9) installed in flow con-
t r o l v a l v e . T i g h t e n h o s e f i t t i n g s e c u r e l y .
Route hose (4) between right steering cylinder assembly and steering
gear. Connect and tighten hose (4) fitting to elbow (15) installed in
steering gear port A. Tighten hose fitting securely.
Connect and tighten fitting on other end of hose (4) to tee (20) in-
s t a l l e d i n r i g h t s t e e r i n g c y l i n d e r a s s e m b l y p o r t . T i g h t e n f i t t i n g s e -
c u r e l y.
Route hose (3) between steering gear OUT port and flow control valve.
Connect and tighten hose (3) fittings. Tighten securely.
Install new 0-ring (2) on hose (1) fitting. Route hose between steering
gear and flow control valve.
Connect hose (1) fitting to flow control valve and tighten securely.
Connect fitting on opposite end of hose (1) to connector (11) installed
in IN port of steering gear. Tighten fitting securely.
Fill hydraulic reservoir with oil (page 11-79) .
T i g h t e n h y d r a u l i c r e s e r v o i r f i l l c a p.
Start engine and operate at idle speed.
Before performing following step, warn personnel to stay away from sides
o f l o a d e r b e t w e e n f r o n t a n d r e a r c h a s s i s . F a i l u r e t o d o s o w i l l c a u se
death or serious injury to those personnel due to chassis pivoting and
c r u s h i n g t h e m .
I f p e r s o n n e l a r e i n j u r e d , o b t a i n m e d i c a l a s s i s t a n ce
immediately.
(am) Turn steering wheel through several complete turns to bleed any air from
hydraulic system.
(an) Turn off engine and check for oil leaks. Tighten fittings as necessary .
(ao) Install engine left side panels (page 9-17).
8-27
