TM 5-3805-262-20
8-2. STEERING SYSTEM MAINTENANCE (CONT)
c. A u x i l i a r y
Steering System (cont).
(2) Replacement (cont).
INSTALLATION (SHEET 1 OF 2)
(a) Position clamp (11) on one end of hose (8) then connect hose to manifold
by pushing it onto manifold port.
(b)
(c)
(d)
( e )
( f )
(g)
(h)
( i )
Position clamp (11) on end of hose (8) and tighten clamp.
Install new 0-ring (10) on elbow (9) and install elbow in auxiliary
steering pump and motor port. Tighten securely.
Position clamp (7) on end of hose (8) then connect hose to elbow (9) by
pushing it onto elbow.
Position clamp (7) on end of hose (8) connected to elbow (9) and tighten
clamp.
Install new 0-ring (6) on elbow (5) . I n s t a l l e l b o w i n a u x i l i a r y s t e e r i ng
pump and motor port. Tighten securely.
Install check valve (4) making sure that arrow marked on it is pointing
away from auxiliary steering pump and motor.
Position hose (2) between check valve (4) and fitting (3) then connect
and tighten hose (2) fittings to check valve and fitting.
If vacuum pump is used, turn off vacuum pump, and disconnect from hy-
draulic reservoir fill cap opening. Go to step (k) below.
8-32
