TM 5-3805-262-20
REMOVAL
(1)
(2)
(3)
(4)
Remove two nuts (1).
Cut, remove, and discard three tie straps (2) securing grease hose (3) to
wiring harness .
Beneath loader, loosen, disconnect, and remove grease hoses (3 and 4)
from elbows (5) at trunnion assembly pivot pins.
If necessary, remove two elbows (5) from pivot pins.
INSTALLATION
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
We-ar protective goggles and gloves and use only in a
a r e a . A v o i d c o n t a c t w i t h s k i n , e y e s a n d c l o t h e s a nd
v a p o r s . D o n o t u s e n e a r o p e n f l a m e o r e x c e s s i v e h e at
w h e n u s i n g i t . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s
b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e sh
a t t e n t i o n i m m e d i a t e l y . I f c o n t a c t w i t h s k i n o r c l o t h es
w i t h l a r g e a m o u n t s o f w a t e r . I f c o n t a c t w i t h e y e s is
with water and get medical aid immediately.
w e l l v e n t i l a t ed
d o n ’ t b r e a t he
and don't smoke
i n j u r y . I f y o u
air and medical
i s m a d e , f l u sh
made, wash eyes
(1)
(2)
(3)
(4)
(5)
(6)
(7)
( 8)
Using clean cloth moistened with cleaning solvent, remove all dirt and
grease from exterior of elbows (5), and fittings on both ends of grease
hoses (4 and 3).
Beneath loader, at trunnion assembly pivot pins,
install two elbows (5).
Route grease hoses (4 and 3) between left side support and elbows (5).
Connect and tighten grease hoses (4 and 3) straight fitting to elbows
( 5 ) .
I n s t a l l g r e a s e h o s e s ( 4 a n d 3 ) l u b r i c a t i o n f i t t i n g s i n l e f t s i d e s u p p o rt
mounting holes and secure using two nuts (l).
Install three tie straps (2) to secure grease hose (3) to wiring harness.
Using grease gun, apply grease to grease hoses (3 and 4) lubrication fit -
tings until grease just oozes out of pivot pin.
Reinstall engine left side panels (page 9-17).
9-7
