TM 5-3805-262-20
10-4. WINDSHIELD WIPER MOTOR MAINTENANCE (CONT)
b. Front Wiper Switch and Circuit Breaker (cont).
INSTALLATION (SHEET
(1)
(2)
(3)
(4)
( 5)
(6)
P o s i t i on
s t a l l i ng
1 OF 2)
circuit breaker (13) on cab switch panel (4) and secure by in-
and tightening round nut (12).
Check insulation of wire lead (10) for cracks, breaks, or other defects;
repair by applying insulation tape over area. Check for broken wire
strands where spade terminals are crimped to wire. If broken wire strands
are seen replace wire lead (10).
Connect wire lead (10) spade terminal (9) to circuit breaker (13) termin-
al by firmly pushing spade terminal onto circuit breaker terminal.
Connect wiring harness red-white wire spade terminal (11) to circuit
breaker (13) terminal.
Position FRONT WIPER switch (8) on cab switch panel (4) and secure by
i n s t a l l i n g a n d t i g h t e n i n g n u t ( 7 ).
Connect wire lead (10) spade terminal (6) to switch (8) terminal marked B
by firmly pushing spade terminal onto switch terminal.
10-20
