TM 5-3805-262-20
INSTALLATION (SHEET 2 OF 2)
(7) Connect three wiring harness spade terminals (5) to switch (8) terminals:
orange-blue wire spade terminal to switch terminal marked L; tan-black
wire spade terminal to switch terminal marked H; and black-yellow wire
spade terminal to switch terminal marked P.
(8) Carefully position cab switch panel (4) on heater console being careful
not to pinch wiring or disconnect wiring harness spade terminals.
( 9 ) I n s t a l l a n d t i g h t e n f o u r s c r e w s ( 3 ) .
( 1 0 ) I n s t a l l k n o b s ( 2 a n d 1 ) b y p u s h i n g f i r m l y d o w n o n t o a s s o c i a t e d s h a f t .
(11) Connect battery ground cable (page 5-151).
(12) Set key switch to ON position and set FRONT WIPER switch to HI position
then to L0 position. Check that wiper blade moves. Set key switch to OFF
position and FRONT WIPER switch to OFF position. If wiper blade does not
move, refer to troubleshooting procedures (page 3-159).
1 0 - 2 1
