TM 5-3805-262-2010-4. WINDSHIELD WIPER MOTOR MAINTENANCE (CONT)b. Front Wiper Switch and Circuit Breaker.This task covers removal and instal-lation of front wiper switch and circuit breaker.TOOLS: No. 1 Common Organizational Maintenance Tool KitS l i p j o i n t p l i e rsFixed open end wrench setScrewdriverMATERIALS/PARTS: Insulation tape (Appendix C, item 5)NOTEPRELIMINARY PROCEDURE: Battery ground cable disconnected (page 5-148).REMOVAL (SHEET 1 OF 2)(1) At cab switch panel located to left of operator's seat, remove HEAT CON-TROL knob (1) and FRONT WIPER knob (2) by pulling straight up off asso-c i a t e d c o n t r o l s h a f t.( 2)Remove four screws (3).(3) Carefully pull cab switch panel (4) up from heater console just enough togain access to wiring harness spade terminals on back of cab switchp a n e l.10-18
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business