TM 5-3805-262-2010-5. WINDSHIELD WASHER MAINTENANCEThis task covers removal, cleaning, inspection, and installation of the windshieldwasher and its associated components.TOOLS: No. 1 Common Organizational Maintenance Tool KitFixed open end wrench setS l i p j o i n t p l i e rsMATERIALS/PARTS: Clean cloths (Appendix C, item 1)Cleaning solvent P-D-680 (Appendix C, item 2)Detergent (Appendix C, item 3)Cleaning compound (Appendix C, item 25)PERSONNEL REQUIRED: Two Construction Equipment Mechanics M0S 62BNOTEPRELIMINARY PROCEDURE: Front access door unlocked and open and air res-ervoir drain valve opened.REMOVALa .b .c .d.e .f .g.h .i .j .At top of reservoir (3) disconnect hoses (1 and 2) by firmly pulling off res-e r v o i r t u b e s.If necessary, remove reservoir (3) by lifting up and off its mounting bracketwelded to side of front chassis.Inside cab,just behind steering column, disconnect tube (1) from nozzle (5)by pulling tube from end of nozzle. If necessary, remove tube (1) by pullingit through hole in front chassis floor plate.While an assistant holds nozzle (5) outside front chassis using open endwrench, loosen and remove nut (4). Tell assistant to remove nozzle (5).Inside cab, at left instrument panel, disconnect tube (2) from valve (9) bypulling tube from valve. If necessary, remove tube by pulling it through holei n f r o n t c h a s s i s f l o o r p l a t e .Loosen and disconnect fitting on end of hose (6) connected to elbow (10).If necessary, disconnect other end of hose (6) from tee installed in parkingbrake valve port. Remove hose (6) from cab.Loosen and remove knob (7) from valve (9).Loosen and remove nut (8) then remove valve (9).Remove elbow (10) from valve (9) port.10-22
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business