TM 5-3805-262-20
INSTALLATION (SHEET 2 OF 2)
(4)
(5)
(6)
(7)
( 8)
( 9 )
(10)
(11)
(12)
(13)
(14)
Position circuit breaker (13) on cab switch panel (3) and install and
tighten round nut (12) .
Position DEFROSTER switch (11) on cab switch panel (3) and install and
t i g h t e n n u t ( 1 0 ) .
Connect wiring harness green wire spade terminal (7) to double spade
terminal (8) by grasping terminal (7) with your fingers and firmly push-
ing onto double spade terminal.
Connect wiring harness red-white wire spade terminal (6) to circuit
breaker (13) terminal .
Connect wiring harness brown-white wire spade terminal (5) to DEFROSTER
switch (11) terminal.
Connect wire lead (4) spade terminals to double spade terminal (8) and
DEFROSTER switch (11) terminal.
Check and ensure that connections made in steps (6) through (9) above are
correct. Then, install cab switch panel (3) on heater console taking care
not to disconnect or pinch wiring between switch panel and heater con-
s o l e.
Install and tighten four screws (2) to secure switch panel (3) to heater
console.
Install HEAT CONTROL knob (1) and DEFROSTER knob (9) by firmly pushing
o n t o a s s o c i a t e d s h a f t .
Connect battery ground cable (page 5-151).
Start engine and operate at idle speed. Set DEFROSTER switch to ON posi-
tion. Check that defroster operates. Set DEFROSTER switch to OFF posi-
t i o n . T u r n o f f e n g i n e . I f d e f r o s t e r d o e s n o t o p e r a t e , r e f e r t o t r o u b l e -
shooting (page 3-169).
10-61
