TM 5-3805-262-344-3. TRANSMISSION MAINTENANCE (CONT)a. TransmissionTorqueConverterGroup (Cont).REASSEMBLY (SHEET 2 OF 3)( 3)( 4)( 5)(6)(7)( 8)( 9)Lubricate new seal (27) using lubricating oil and position on drive gear(25). Install two 1/4-28 studs in drive gear.Position converter pump (29) on drive gear (25). Remove two 1/4-28 studsand install retaining plate (24)Position six new lock plates(23) and install 12 capscrews(22) to secure retaining plate(24), converter pump (29), anddrive gear (25).Install converter pump (29) andassembled parts (22 thru 28) ina soft jawed vise with drivegear in jaws of vise. Tightenevery other capscrew (22) to120 to 144 lb-in. until allcapscrews are tight.Using channel lock pliers, bendtabs of lock plates (23)against heads of capscrews(22).Put turbine housing (21) in hy-draulic press with a supportunder its center. Positionbearing (20) with manufactur-er-s identification upward onturbine housing and press ontohub of turbine housing. Use1-3/4 inches outside diametersleeve bearing on inner race ofbearing.Put turbine assembly (17) inhydraulic press with a supportunder its center. Positionbearing (18) with manufactur-er-s identification upward andpress firmly into turbine as-sembly (17) hub seat using2-1/2 inches outside diametersleeve bearing on inner race ofbearing.on converter pump.4-104
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business