4-6. CHASSIS SPINDLE ASSEMBLY MAINTENANCE

REMOVAL (SHEET 1 OF 2) - TM-5-3805-262-34_1195

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
1175

TM 5-3805-262-34 4-6. CHASSIS SPINDLE ASSEMBLY MAINTENANCE This task covers removal, cleaning, inspection, and installation of chassis spindle assembly. TOOLS: No. 1 Common Organizational Maintenance Tool Kit Safety glasses Socket wrench set, 3/4 inch drive Fixed open end wrench set Scratch wire brush Mechanical puller kit Trestle, motor vehicle maintenance (jack stands) Torque wrench, 3/4 inch drive Jacks Hydraulic pusher Chocks, ten Thickness gage Tap, 5/8-11 Sleeve or rod, 3-7/8 inches outside diameter Sleeve or rod, 4-1/4 inches outside diameter Sleeve, 2-9/16 inches inside diameter Hydraulic press MATERIALS/PARTS: Clean cloths (Appendix C, item 1) Cleaning solvent P-D-680 (Appendix C, item 2) Grease (Appendix C, item 7) O-rings (FSCM 10988 PN A30895) Shim (FSCM 10988 PN L17212) Shim (FSCM 10988 PN L17213) Shim (FSCM 10988 PN L17318) REFERENCES: TM 5-3805-262-20 LO 5-3805-262-12 NOTE PRELIMINARY PROCEDURE: Transport/service link engaged, chocks placed at front and rear of each tire, heater hoses and clamps removed, control valve hose disconnected from tube at hydraulic pump, hose between flow control valve and check valve disconnected at check valve, front and rear wiring harness connectors (located above transmission) discon- nected, and center drive shaft removed (refer to TM 5-3805-262-20). 4-250

Privacy Statement
Press Release
Contact