TM 5-3805-262-34
REMOVAL (SHEET 2 OF 2)
(17) Install drive coupling on camshaft.
(18) Prevent camshaft from rotating as shown. Remove
weight pin wrench.
(19) Remove flyweight (23) using flyweight extractor
shown.
(20) Remove lock washer (22).
round nut (21) using fly-
and open end wrenches as
(21) Remove key (24) from fuel injection pump camshaft.
(22) Remove camshaft from fuel injection pump (page 3-142).
(23) Remove screw (25), lock washer (26), and lever bracket (27).
(24) Remove six screws (28) and lock washers
In following step, tap housing (30) straight
The camshaft bearing support fits snugly in
and may break off if housing (30) is twisted
(29).
back from injection pump.
the injection pump housing,
during removal.
(25) Use plastic hammer to loosen housing (30), then remove housing (30) and
gasket (31). Discard gasket (31).
(26) Remove plug (35) from housing (30).
3-171
