TM 5-3805-262-34
3-4. ALTERNATOR REPAIR (CONT)
DISASSEMBLY (SHEET 3 OF 4)
w.
Mount pulley (40) in vise with soft jaws, loosen lock nut (38), and remove
pulley (40) from vise.
x. Remove locknut (38), washer (39), pulley (40), and fan (41).
y.
Remove dust shield (42) and outer collar (43) from rotor (44) shaft.
NOTE
Perform following steps only if inspection indicates need for replace-
ment of parts.
z.
Remove rotor (44):
(1)
Slide paper tube
slip ring end of
onto
rot or
(44) shaft to protect
slip rings.
(2)
Position drive end frame
(52) on hydraulic press
table blocks.
Leave enough space between hydraulic
press table blocks for removal of
rotor. Do not allow rotor to fall
when pressed out of drive end frame.
(3) Press rotor (44) from drive end
aa.
ab.
frame (52) using hydraulic press
and appropriate driver on center
of rotor shaft.
Remove three capscrews (45), retainer (46), and inner collar (47) from drive
end frame (52).
Pry felt washer (48) from retainer (46). Discard felt washer (48).
3-206