TM 5-3805-262-34
3-4. ALTERNATOR REPAIR (CONT)
REASSEMBLY (SHEET 4 OF 5)
n.
o.
p.
q.
r.
s.
t.
u.
v.
Push cap (37) onto connector
(36).
Install connector (36),
bracket (35), lock washer
(34), and capscrew (33) on
slip ring end frame.
Push insulator (32) onto
voltage regulator (29)
terminals.
Connect electrical lead
(31) to voltage regulator
(29) terminal stud and
install nut (30).
Push voltage regulator (29)
terminals into connector
(36).
Install two springs (28) in brush holder (26) and push two brushes (27) onto
springs (28). Push brushes into brush holder, then insert a toothpick
through holes in brush holder and brushes to hold brushes in position.
Aline three holes in brush
holder (26) with three holes in
voltage regulator (29). Guide
end of toothpick in brush holder
through hole in slip ring end
frame, and position brush holder
on voltage regulator.
Install and tighten capscrews
(24 and 25).
Install rectifier bridge (23) and two capscrews (22).
3-220
