TM 5-3805-262-34
3-6. WIRING HARNESSES MAINTENANCE (CONT)
b. Rear Wiring Harness (Cont).
REMOVAL (SHEET 6 OF 6)
(26)
(27)
(28)
(29)
(30)
(31)
At left rear of engine block, remove hardware securing clamp holding rear
wiring harness and blackout lights wiring harness. Remove rear wiring
harness from clamp.
At timing gear cover, beneath alternator, remove hardware securing clamp
holding rear wiring harness and blackout lights wiring harness. Remove
rear wiring harness from clamp.
At left side of radiator, at mounting bracket, remove hardware securing
clamp. Remove rear wiring harness from clamp.
At left and right sides of radiator guard, remove hardware securing
clamps holding rear wiring harness and blackout lights wiring harness.
Remove rear wiring harness from clamps.
Cut, remove, and discard tie straps as required to remove rear wiring
harness from loader.
Remove rear wiring harness from loader.
NOTE
Perform following steps only if replacement of mounting bracket is ne-
cessary.
(32) Remove nut (1), lock washer (2), capscrew (3), clamp (4), and spacer (5).
(33) Position heater hoses away from mounting bracket (8).
(34) Remove two capscrews (6) and lock washers (7). Remove mounting bracket
(8) from charging pump.
3-274
