TM 5-3805-262-34
INSTALLATION (SHEET 1 OF 8)
(1)
If removed, position mount-
ing bracket (8) on transmis-
ion charging pump. Install
and tighten two lock washers
(7) and capscrews (6).
Tighten capscrews to 26 to
32 lb-ft.
(2)
Position heater hoses on
mounting bracket (8). Put
clamp (4) and spacer (5) on
capscrew (3) then install
capscrew through hole in
mounting bracket with spac-
er between heater hoses.
(3) Position heater hoses be-
neath clamp (4) then in-
stall lock washer (2) and
nut (1). Tighten nut se-
curely.
NOTE
Spray all terminals and contacts
with electrical cleaner and allow
to air dry before making con-
nections.
LEGEND
Nut
Lock washer
Capscrew
clamp
Spacer
Capscrews (2)
Lock washers (2)
Mounting bracket
(4) Put new rear wiring harness connector on its mounting bracket. Secure
using washer and nut. Use one tie strap and secure rear wiring harness to
blackout wiring harness.
3-275
