TM 5-3805-262-34
REMOVAL (SHEET 2 OF 6)
(2)
( 3 )
( 4 )
( 5 )
( 6)
(7)
( 8)
( 9)
Remove rear wiring harness connector from mounting bracket by loosening
and removing nut and washer.
At right side of transmission, at control valve, disconnect rear wiring
harness violet-black wire terminal from neutral start switch.
At right side of loader, at right side of air reservoir, disconnect rear
wiring harness red-green wire terminal from air pressure sender.
At right side of transmission, near control valve, disconnect rear wiring
harness yellow-red wire terminal from converter temperature sending unit.
At transmission control valve, disconnect rear wiring harness violet-red
wire spade terminal and black-red wire spade terminal from backup alarm
switch spade terminals. Do this by grasping terminals with fingers and
firmly pulling apart.
At right front of engine, at water manifold, disconnect rear wiring har-
ness blue-yellow wire terminal from water temperature sending unit.
At steering hydraulic filter, disconnect rear wiring harness gray-white
wire terminal from filter switch installed in filter head.
At left side of loader, near side support at cold start solenoid, discon-
nect black-orange wire terminal from cold start solenoid wire terminal.
Do this by grasping both terminals with your fingers and firmly pulling
apart.
3-269
